Applying to join this forum, you HAVE to activate your membership in YOUR email in the notice you recieve after completing application process. No activation on your part, no membership.

Lapidaryforum.net

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome new members & old from the Lapidary/Gemstone Community Forum. Please join up. You will be approved after spam check & you must manually activate your acct with the link in your email

Congratulations to Bobby1 and his Brazilian Agate Cab!

 www.lapidaryforum.net

Another cabochon contest coming soon!

Pages: [1]   Go Down

Author Topic: Feed rates  (Read 1782 times)

0 Members and 2 Guests are viewing this topic.

melvinrose

  • Newbie
  • *
  • Offline Offline
  • Posts: 8
Feed rates
« on: March 13, 2023, 05:24:44 PM »

Me again. My 18” Highland Park lapidary saw has three different pulleys for three different feed rates based on the harness of the material being sawed. I’m not in production to saw as much stuff as possible so I intend to just saw everything, hard and soft, at the lowest feed rate. Will this be an okay thing to do, or will I need to saw faster for softer stuff? Tx, Melvin
Logged

peruano

  • Retired Zoologist
  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 410
Re: Feed rates
« Reply #1 on: March 14, 2023, 05:05:06 AM »

I've heard contrary opinions, but slow works for me and in my eyes saves blades, less likely to leave saw marks, and I never shift to higher speeds.  Good blades last for years even with high use. 
Logged
Combining a love of bikes (pedal and otherwise) with hiking, hounding, lapidary, and the great outdoors

melvinrose

  • Newbie
  • *
  • Offline Offline
  • Posts: 8
Re: Feed rates
« Reply #2 on: March 14, 2023, 05:35:29 AM »

Thanks for the advice. I agree. I only saw for myself and I’m not afraid to do other things and just let the saw do its thing. I stay within earshot in case something goes wrong but so far it hasn’t.
Logged

R.U. Sirius

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 283
  • asleep at the grinding wheel
Re: Feed rates
« Reply #3 on: March 14, 2023, 02:50:41 PM »

The thinking goes that slowing the feed rate (and thus lowering the radial force) too much below optimal values leads to unnecessary wear on the blade, possibly glazing-over as well.

In my opinion, it's a small price to pay to ensure that you are avoiding a much more problematic situation where feed rate is too high, leading to dished blades, stressed carriage and feed system, and expensive catastrophic failures. Better too slow than too fast.
Logged
Pages: [1]   Go Up
 

Page created in 0.086 seconds with 30 queries.