Applying to join this forum, you HAVE to activate your membership in YOUR email in the notice you recieve after completing application process. No activation on your part, no membership.

Lapidaryforum.net

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome new members & old from the Lapidary/Gemstone Community Forum. Please join up. You will be approved after spam check & you must manually activate your acct with the link in your email

Congratulations to Bobby1 and his Brazilian Agate Cab!

 www.lapidaryforum.net

Another cabochon contest coming soon!

Pages: [1]   Go Down

Author Topic: Mexica Dollar Ring  (Read 1744 times)

0 Members and 1 Guest are viewing this topic.

olgguy

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 370
Mexica Dollar Ring
« on: February 24, 2018, 10:42:46 AM »

This coin is very hard metal, Nickle/ copper alloy. Lots of annealing.
Logged

Jhon P

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1755
Re: Mexica Dollar Ring
« Reply #1 on: February 24, 2018, 12:21:36 PM »

Cool, did you use a hammer and mandrel? Or folding dies.  Silver coins are much easier to do than the copper  nickel
Logged

olgguy

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 370
Re: Mexica Dollar Ring
« Reply #2 on: February 24, 2018, 12:42:16 PM »

yes, drill hole, hammer and mandrel, then in a dapping block and compressed in hydraulic press half way and turned over and compressed the other side to form the domed profile.
Logged

Sapphireminer

  • Full Member
  • ***
  • Offline Offline
  • Posts: 183
Re: Mexica Dollar Ring
« Reply #3 on: February 24, 2018, 03:07:46 PM »

Hi olgguy nice job on the ring watched some clips on youtube on making them plenty of elbow grease needed.
Dave
Logged

olgguy

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 370
Re: Mexica Dollar Ring
« Reply #4 on: February 24, 2018, 04:10:04 PM »

There are "How to" on Pinterest. Some posts are for specialized tools someone is making.
Logged
Pages: [1]   Go Up
 

Page created in 0.098 seconds with 32 queries.