Lapidaryforum.net

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome new members & old from the Lapidary/Gemstone Community Forum. Please join up. You will be approved after spam check & you must manually activate your acct with the link in your email

Congratulations to Asianfire and his Montana Agate cab!

 www.lapidaryforum.net

Another cabochon contest coming soon!

Pages: [1]   Go Down

Author Topic: Anyone cut this material? Pyrite fossils  (Read 178 times)

0 Members and 1 Guest are viewing this topic.

MurphyStone

  • Newbie
  • *
  • Offline Offline
  • Posts: 45
Anyone cut this material? Pyrite fossils
« on: July 19, 2017, 11:55:24 AM »

I believe it is a relative new find out of western NY?  It is a pyrite fossil replacement.  I have a few pounds waiting for me on my front porch, but curious if anyone else has cut it yet. 

 





Logged


ileney

  • Full Member
  • ***
  • Offline Offline
  • Posts: 145
Re: Anyone cut this material? Pyrite fossils
« Reply #1 on: July 19, 2017, 01:51:51 PM »

I've never seen it before. Thank you for sharing. It's very, very nice looking. It kind of reminds me of that gray crinoid fossil stone, but smaller and metallic.
Logged

irockhound

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 488
    • RockhoundingUSA
Re: Anyone cut this material? Pyrite fossils
« Reply #2 on: August 08, 2017, 02:07:23 PM »

I sent you a message a while back and wondered where you got the material from.  I was interested in getting some to do some cabs.  Let me know if it is a vendor or person you can share.  Thanks, Steve
Logged

Pusscat

  • Newbie
  • *
  • Offline Offline
  • Posts: 16
Re: Anyone cut this material? Pyrite fossils
« Reply #3 on: August 10, 2017, 11:22:08 PM »

That's quite beautiful!
Logged

MurphyStone

  • Newbie
  • *
  • Offline Offline
  • Posts: 45
Re: Anyone cut this material? Pyrite fossils
« Reply #4 on: August 17, 2017, 04:50:47 AM »

I sent you a message a while back and wondered where you got the material from.  I was interested in getting some to do some cabs.  Let me know if it is a vendor or person you can share.  Thanks, Steve

Sorry I missed it I don;t check for messages unless I see something flashing on the forum I am on.  I'll go check now.  I only obtained 3#'s, but can put you in touch with my source.

EDIT I just checked and I didn;t have a PM from you.  Just sent you one.

John
Logged
Pages: [1]   Go Up
 

Page created in 0.096 seconds with 30 queries.