Lapidaryforum.net
Gadgets, Gizmos, and Dohickeys => Fixing, Modifying and Refurbishing your Lapidary Equipment => Topic started by: Grayco on March 15, 2017, 12:38:21 PM
-
I posted this on another forum but I believe it is good to put it here also.
I needed to clean up the feed drive slip clutch on a 20" saw I'm restoring. I have been reading posts that suggest PB Blaster, WD-40 and even a mixture of ATF and Acetone for rust removal.
WD-40 is a great water displacing fluid and it does help loosen frozen parts but it does not dissolve rust. PB Blaster is a great penetrant but also does not dissolve rust. ATF and Acetone??? Well I haven't tried it. ATF is really high detergent and acetone would certainly help penetrate.
I used distilled vinegar. I soaked my rusty parts overnight in white distilled vinegar. The next day I just brushed the rust away. Even the chain links all loosened up. After the soak and brushing, I hosed the parts off and soaked them in WD-40 overnight.
I am very impressed with the results. My only concern is the need to neutralize the vinegar to avoid future corrosion. So far it looks great!
-
That's looking nice.
I'm restoring a 1939 Ford 9N tractor. That's 77 years of rust. For some of the smaller parts I use electrolytic rust removal. Works great!
http://www.instructables.com/id/Electrolytic-Rust-Removal-aka-Magic/
-
Use a solution of baking soda and water to neutralize the vinegar.
-
Use a solution of baking soda and water to neutralize the vinegar.
I considered that, but then you need to neutralize the baking soda. I just settled for a good water rinse and wd-40 to eliminate the water.
BTW... WD stands for Water Displacement and 40 stands for the 40th formula https://en.wikipedia.org/wiki/WD-40