Lapidaryforum.net

Gadgets, Gizmos, and Dohickeys => Fixing, Modifying and Refurbishing your Lapidary Equipment => Topic started by: rockherder on July 06, 2017, 03:49:17 PM

Title: Pillow Bearing Replacement on Highland Park 20" Saw
Post by: rockherder on July 06, 2017, 03:49:17 PM
One of the pillow bearings (closest to the saw) is making horrific noises.
I'm just wondering how hard it is to replace these.
Anyone have any experience with these?
Title: Re: Pillow Bearing Replacement on Highland Park 20" Saw
Post by: Slabbercabber on July 06, 2017, 06:23:45 PM
If you are mechanically inclined, it is pretty straightforward.  It is hard to tell form the the photo but the bearings themselves may be replaceable in the pillow block housing.  Called cartridge bearings.  They appear to be Sealmaster.  Call any industrial bearing supply and give them the part number.  They will be able to tell you what is needed.
Title: Re: Pillow Bearing Replacement on Highland Park 20" Saw
Post by: 55fossil on July 06, 2017, 07:15:47 PM
   Seriously, replacing them is easy. Re-aligning the saw to cut straight is not hard but you need to take your time and do it right. Square the blade up and make sure your vice is tight to the rails. Also, I would pull the bearings and take one with you after you clean it up. Get the right part the first time.
Title: Re: Pillow Bearing Replacement on Highland Park 20" Saw
Post by: FLRocks on July 08, 2017, 06:35:51 PM
If You're replacing one might as well replace the other one too.




Sent from my iPad using Tapatalk