Lapidaryforum.net

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome new members & old from the Lapidary/Gemstone Community Forum. Please join up. You will be approved after spam check & you must manually activate your acct with the link in your email

Congratulations to Sandsave and his Crinoid Cab!

 www.lapidaryforum.net

Another cabochon contest coming soon!

Pages: [1]   Go Down

Author Topic: Motor Upgrade  (Read 275 times)

0 Members and 1 Guest are viewing this topic.

MurphyStone

  • Full Member
  • ***
  • Offline Offline
  • Posts: 143
Motor Upgrade
« on: June 13, 2018, 05:53:52 AM »

Finally tired of burning out 1/3HP motors (sourced used) probably near 7 of them in the last 4 years.  So I grabbed some wood and set it back a couple inches to avoid the autofeed and hung a new 1HP on it.  Hopefully this will solve the motor problems, some of them were from a bad bearing causing some pinch and excessive load on it.  I replaced both bearings and have new split nut pieces on the way.  It should run like a champ soon.



Logged


Pages: [1]   Go Up
 

Page created in 0.128 seconds with 25 queries.