Lapidaryforum.net

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome new members & old from the Lapidary/Gemstone Community Forum. Please join up. You will be approved after spam check & you must manually activate your acct with the link in your email

Congratulations to auscarver and his Rhodonite/Jasper Cab!

 www.lapidaryforum.net

Another cabochon contest coming soon!

Pages: [1]   Go Down

Author Topic: Tubing for sander/grinder. Copper or Plastic  (Read 291 times)

0 Members and 1 Guest are viewing this topic.

rockherder

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 61
Tubing for sander/grinder. Copper or Plastic
« on: August 24, 2018, 10:19:44 AM »

I've seen this stuff advertised and it seems like it would work. 
Anybody have any experience with this?
Logged


-Doug in El Dorado Hills, CA

Slabbercabber

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 400
Re: Tubing for sander/grinder. Copper or Plastic
« Reply #1 on: August 24, 2018, 12:28:21 PM »

My whole system is plumbed with that stuff.  Different brand but I doubt that matters.  I like it because I don't have to worry about leaks and if I want to change something it only takes seconds.
Logged

bilquest

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 59
    • Rocks and Stuff
Re: Tubing for sander/grinder. Copper or Plastic
« Reply #2 on: August 24, 2018, 06:43:28 PM »

I use quarter-inch garden drip tubing. Lots of options for routing water and tapping sources with tees, couplers and whatnot. It goes nicely into standard brass valves and is very cheap.
Logged
Pages: [1]   Go Up
 

Page created in 0.112 seconds with 31 queries.