Lapidaryforum.net

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome new members & old from the Lapidary/Gemstone Community Forum. Please join up. You will be approved after spam check & you must manually activate your acct with the link in your email

Congratulations to ToTheSummit and his Condor Cab!

 www.lapidaryforum.net

Another cabochon contest coming soon!

Pages: 1 [2]  All   Go Down

Author Topic: Super Glue Dopping - Screws instead of Nails  (Read 4726 times)

0 Members and 1 Guest are viewing this topic.

bilquest

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 59
    • Rocks and Stuff
Re: Super Glue Dopping - Screws instead of Nails
« Reply #15 on: April 02, 2019, 11:44:35 AM »

Gotta chime in here with my tried and proven dop method... basically, dowel sticks of various width, cut to about 5" lengths. Painted with some colorful enamel paint to waterproof the wood. Then the secret sauce, E6000 glue. Put a dab of glue on the end of the dowel and press onto the back of the cab. It's sticky enough that it will stand up straight until it dries (coupla hours). When you're done cabbing, simply use your thumb to pry the stone from the stick. It's a rubbery glue and if any sticks to the stone, simply scrape it off with a razor blade or you can even peel it off with a finger nail. I guess the only downside is the wait for the glue to dry.
Logged

kenny

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 70
Re: Super Glue Dopping - Screws instead of Nails
« Reply #16 on: April 03, 2019, 08:23:39 AM »

I make and use these they are aluminum dop handles with a set screw that holds the dop head of various sizes. Nails and bolts will also work. I have made handles up to 1" diameter. The normal dop heads are 1/4" stem with 1/4, 3/8, 1/2 inches heads. I can make them to any desired size

Logged

rocks2dust

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 383
    • rocks2dust items on ebid.net
Re: Super Glue Dopping - Screws instead of Nails
« Reply #17 on: April 04, 2019, 10:08:21 AM »

Somebody used to sell aluminum dops for cyanoacrylate glue. They had flat heads in various sizes with notches and holes drilled through so that the acetone could get into the interior and dissolve the glue much faster. Not sure what happened to them, as I haven't seen them for several years. Was a good idea.
Logged
r2d

surplus odds and ends that I have on ebid.net
· Xtra gemstones
· Xcess fossils, minerals and rough
· Everything else
Pages: 1 [2]  All   Go Up
 

Page created in 0.079 seconds with 31 queries.