Lapidaryforum.net

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome new members & old from the Lapidary/Gemstone Community Forum. Please join up. You will be approved after spam check & you must manually activate your acct with the link in your email

Congratulations to ToTheSummit and his Condor Cab!

 www.lapidaryforum.net

Another cabochon contest coming soon!

Pages: 1 2 [3]   Go Down

Author Topic: rehabilitating 24" Nelson saw  (Read 818 times)

0 Members and 1 Guest are viewing this topic.

robirdman

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 98
Re: rehabilitating 24" Nelson saw
« Reply #30 on: September 12, 2019, 01:02:50 PM »

I try to get 2 closest to the left one, thanks.
Logged

robirdman

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 98
Re: rehabilitating 24" Nelson saw
« Reply #31 on: September 13, 2019, 04:39:59 AM »

Looked up McMaster and what a great resource!.  I had a metric ruler and measured, but then saw all their measurements were in decimal fractions of an inch.  I thought maybe I needed a micrometer or something, and maybe I could send to them to get the right type.  Then I see the address in Elmhurst and my phone shows as only 48' away! So I can just bring it there, validate type, gauge, etc!
Logged

robirdman

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 98
Re: rehabilitating 24" Nelson saw
« Reply #32 on: September 13, 2019, 07:28:59 AM »

Unfounded optimism.  Called and just a will call warehouse, can't look at anything.  I need a micrometer for accurate measurement of the gauge wire.
Logged
Pages: 1 2 [3]   Go Up
 

Page created in 0.059 seconds with 31 queries.